WebTwo additional outlets at the pump supply oil to the right-hand cylinder, but the system works the same. Oil is injected to all the main bearings except the one located next to … WebJan 25, 2013 · Suzuki used a delivery formula of approx 20:1 for the pumps output settings when with todays oils 32:1 would be more suitable, so it can be adjusted to a degree. So what all this translates to is the new pump setting where the marks don't line up.

Working on David

WebMay 5, 2014 · The oil seal (9.5 x 16 x 4) at the bottom of the pump seems very loose on the shaft. The oil seal (8 x 14 x 4) on the top side seems a slightly tighter fit. I checked the seals out of another pump and it was the same story. … Web2. Remove oil pump cover. 3. Turn throttle grip until mark on throttle slide is at the top of the hole. 4. Loosen pump cable adjuster locknut, then turn cable adjuster until the line on the oil pump aligns with mark on the pump. 5. release the throttle, tighten pump cable locknut, then recheck adjustment. 6. Replace alignment hole cover screw. chest x ray clipart

Auto Parts at Pep Boys

http://www.dansmc.com/2_stroke_oilpump.htm WebThe connecting rods were now fully switched over to floating big-ends, non-floating small ends (at engine number 38060) Crank oil seal changed to replace C clip with an integral steel locating lip to ensure that the seal … http://smokeriders.com/Technical/Suzuki/Oil_Systems/1_2_Cyl/1_2_cyl.html chest x-ray criteria